Plan #12

Lucas Dr , closure type: Shoulder Draft

0 pending edit(s) — click Complete Edits to save or discard below
View mode
TTC Zones
Advance Warning
Transition
Buffer
Activity Area
Termination
Modified

Plan Details

Road Lucas Dr Speed 25 mph (UserEntered) Lanes 2
Closure Shoulder Road Type MultiLaneDivided Status Draft
Template Stationary Work on Shoulder (TTC-4.0) VWAPM v@Model.Plan.VWAPMVersion
Created by Bill B. Plan ID #12

Device Placements 19

# Device MUTCD Code Zone Side Distance (ft) Status
1 ROAD WORK AHEAD W20-1 AdvanceWarning Right -645 Auto
2 SHOULDER CLOSED AHEAD W21-5b AdvanceWarning Right -495 Auto
3 SHOULDER CLOSED W21-5a AdvanceWarning Right -345 Auto
4 TRAFFIC CONE CD-CONE Transition Right -195 Auto
5 TRAFFIC CONE CD-CONE Transition Right -175 Auto
6 TRAFFIC CONE CD-CONE Transition Right -155 Auto
7 TRAFFIC CONE CD-CONE Activity Right 0 Auto
8 TRAFFIC CONE CD-CONE Activity Right 40 Auto
9 TRAFFIC CONE CD-CONE Activity Right 80 Auto
10 TRAFFIC CONE CD-CONE Activity Right 120 Auto
11 TRAFFIC CONE CD-CONE Activity Right 160 Auto
12 TRAFFIC CONE CD-CONE Activity Right 200 Auto
13 TRAFFIC CONE CD-CONE Activity Right 240 Auto
14 TRAFFIC CONE CD-CONE Activity Right 280 Auto
15 TRAFFIC CONE CD-CONE Activity Right 320 Auto
16 TRAFFIC CONE CD-CONE Activity Right 360 Auto
17 TRAFFIC CONE CD-CONE Activity Right 400 Auto
18 TRAFFIC CONE CD-CONE Activity Right 440 Auto
19 END ROAD WORK G20-2 Termination Right 580 Auto

Flagged Issues 1

Date By Category Comments Status
User IncorrectSpacing I have been thinking about our size issue when we put in a small area and then the system gives us a large one based off of the information it is using. I looked in the pocket guide, page 6, under, "Spacing of Advance Warning Signs". For Urban streets it says 25 mph or less: 100'-200. Urban Streets with 30 to 40 mph: 250' to 350. I wonder if we could add this into the set of information it pulls from and if it will be able to differentiate when to use it and when not to. Maybe a an "urban" clickable option that then directs the system to get information from said location? Also, is it possible to make these work zones a transparency that can lay over the desired work zone section? I am trying to find suggestions when I run into an issue. Thanks, John Open